Cylinder 50cc NM Airsal fast T6 set Bing 15mm Puch Maxi, X30

Complete Airsal kit 50cc cylinder new model (38mm)

• Cylinder
• Piston (piston pin 12mm)
• Head
• Manifold,
• 15mm Bing replica carburetor (3.5mm jets!)
• Powerfilter
• All gaskets included
• Complete as pictured.

Cylinder information

• This is the fastest version of the 50cc Airsal. (T6)
• Nice allround cylinder.
• For Puch Maxi / X30 and E50 / Z50 / ZA50 engines
• Cylindersleeve outer diameter: 48mm

Bing 15mm carburetor replica

• Connection diameter of the manifold 20mm
• Connection diameter of the air filter 20mm
• Nozzles/jets suitable for this carburettor are Bing 3.5mm jets/nozzles
• Carburettors are delivered with a blank nozzle/jet, of which the size is unknown.
• Carburettors should always be cleaned before installation.

Before mounting

• We always advise to check and clean the cylinder before installation and to finish the ports in the cylinder with a 1000 grit sandpaper. This way the edges are no longer too sharp because of the Nicasil coating, this will considerably extend the life of the cylinder / piston.

Models

• The cylinder is compatible for use on a Puch Maxi S / Maxi N / Maxi K / Maxi P / X20 / X30, Korado, Manet and KTM hobby with E50 / Z50 / ZA50 engine. Just note that you may have to make some modifications. Want advice on whether this cylinder fits your moped? Please contact us.

Note: 

• Do not overtighten your carburetor to your manifold, as this may cause the clamp to break. No warranty when you have overtightening the clamp!
• So the nozzle should be changed at all times before fitting the carburettor with a nozzle that suits the set-up. So the blank nozzle cannot be used.
• The jet that is mounted in the carburettor / set is blank and different for each batch. (The manufacturer does this because they cannot know on which engine / setup this carburettor will be mounted). It is therefore highly advisable to order a jet-set so that you can always achieve maximum adjustment.