Cylinder 70cc OM Airsal kit + Bing 15mm Puch Maxi, X30

Complete Airsal kit 70cc cylinder set old model (45mm)

• Cylinder
• Piston (piston pin 12mm)
• Head
• Manifold
• 15mm Bing replica carburetor (3.5mm jets)
• Powerfilter
• All gaskets included.
• Complete as pictured.

For this setup you need Bing 3.5mm jets between +/- 68 and 74

Airsal 70cc cylinder (45mm) information

• Piston (piston pin 12mm) and gasket sets included.
• Nice allround cyilinder.
• Model with the "small" cooling fins.
• For Puch Maxi / X30 and E50 / Z50 / ZA50 engines
• Cylindersleeve outer diameter: 48mm 

Bing 15mm carburetor replica

• Connection diameter of the manifold 20mm
• Connection diameter of the air filter 20mm
• Nozzles/jets suitable for this carburettor are Bing 3.5mm jets/nozzles
• Carburettors are delivered with a blank nozzle/jet, of which the size is unknown.
• Carburettors should always be cleaned before installation

Before mounting / note:

• We always advise to check and clean the cylinder before installation and to finish the ports in the cylinder with a 1000 grit sandpaper. This way the edges are no longer too sharp because of the Nicasil coating, this will considerably extend the life of the cylinder / piston.
• Do not overtighten your carburetor to your manifold, as this may cause the clamp to break. No warranty when you have overtightening the clamp!
• So the nozzle should be changed at all times before fitting the carburettor with a nozzle that suits the set-up. So the blank nozzle cannot be used.
• The jet that is mounted in the carburettor / set is blank and different for each batch. (The manufacturer does this because they cannot know on which engine / setup this carburettor will be mounted). It is therefore highly advisable to order a jet-set so that you can always achieve maximum adjustment.