Exhaust Puch Maxi / E50 28mm ADDY H100A overhead (for angled exhaust port)

Exhaust Puch Maxi / E50 28mm ADDY overhead (for angled exhaust port)

This newly developed exhaust is suitable for cylinders with an angled exhaust port (including the 74CC Gilardoni)

• Exclusively at Puchshop!
• Black powder coated
• ADDY type number: H100A
• Unique exhaust and absolutely custom-made

Note:

• Also usable on cylinders with a straight exhaust port with an adapter piece (see related products). Please note that the rear engine point must be changed.
• Cannot be used for kickstart engines. 

Tips:

• Use our long brass M6 nuts in combination with hardened studs (see related products). This so you can easily and fully tighten the exhaust flange. Brass is also softer than steel, so it will not seize.
• Always use a new exhaust gasket when fitting an exhaust

When using all exhausts, black painted, chrome and blanc exhausts, heat build-up at the exhaust manifold can cause the following:

• At black outlets the paint can dissolve a little.
• Chrome and blanc exhaust manifolds may discolour

If the nozzle is too small or if the ignition is set incorrectly, the exhaust port becomes very hot and discoloring and dissolve of the paint on the exhaust manifold will occur faster than a perfectly adjusted engine. We give no guarantee on discoloration or solving of the paint on the exhaust manifold!