Exhaust Puch X50 Homoet P4 black

Exhaust Puch X50 Homoet P4 black

• Fits all Puch X50-2 / X50-3 and X50-4
• Just for models with pedel arms
• Fits good on 50cc and stock 70cc cylinders

Maße:

• A: 260mm
• B: 680mm
• C: 26mm
• D: 28mm
• E: 6mm

Tips:

• Use our long brass M6 nuts in combination with hardened studs (see related products). This so you can easily and fully tighten the exhaust flange. Brass is also softer than steel, so it will not seize.
• Always use a new exhaust gasket when fitting an exhaust

When using all exhausts, black painted, chrome and blanc exhausts, heat build-up at the exhaust manifold can cause the following:

• At black outlets the paint can dissolve a little.
• Chrome and blanc exhaust manifolds may discolour

If the nozzle is too small or if the ignition is set incorrectly, the exhaust port becomes very hot and discoloring and dissolve of the paint on the exhaust manifold will occur faster than a perfectly adjusted engine. We give no guarantee on discoloration or solving of the paint on the exhaust manifold!