Flywheel cover pull starter Puch Z50 Bosch / HPI / PVL / MVT etc. PSR

• Ready-made pull starter for left-handed Puch Z50 engines
• Good quality, can be used without problems with all cylinders from 50cc to 70cc!
• For Bosch / Ducati / Iskra / HPI / HPI 210 / MVT / Selettra ignition
• Beautiful heavy quality

Note: 

• Not usable for Kokusan ignitions
• Only for left-handed Z50 engines!

Mounting:

• Starter pinion: clean the flywheel, remove the original flywheel nut. Then screw the carriage for the pull starter onto the crankshaft. Tip: mount the carrier with loctite.
  
• Pull starter: Place the starter housing in the correct position and tap lightly with a plastic hammer until the pull starter fits perfectly. It can then be screwed into place. 

Application:

• Before starting, pull the cable slowly a few times so that the engine spins empty (must be done before each start attempt).
  
• Pull out the pull-start handle until it is fully engaged and you encounter resistance. Then pull through in one go.
• Tip: Wear gloves! Hold the handle firmly.

Tipp:

• The pedal system can no longer be operated because the pedal arms would touch the housing of the pullstarter. Therefore, footrests, a longer pedal axle or a pedal axle extension must be fitted.